Unit For Temperature Display; Tilt Sensor - Dometic COOLAIR RTX1000 Accessory Installation Manual

CoolAir
8.3 P.02: Unit for temperature display
The system can display the room temperature in °C or °F.
1. Switch to configuration mode (chapter "Entering and exiting configuration
mode" on page 13).
✔ The display shows "P.01" and the
2. Press the
✔ The display shows "P.02" and the symbol lights up.
3. Press the
✔ The code for the current setting is displayed:
– 0: °C
– 1: °F
4. Use the
5. Press the
✔ The set value is saved and is then applied when the system is restarted.
✔ You are then returned to the menu and can select another menu item by
pressing the
8.4 P.05: Tilt sensor
The electronics of the system prevents that the system is switched on when the
vehicle is parked at a slope. Since some vehicles' roof already is tilted, the tilt
sensor has to calibrated to the zero setting before first use.
1. Park the vehicle on a level place.
2. Switch to configuration mode (chapter "Entering and exiting configuration
mode" on page 13).
✔ The display shows "P.01" and the
3. Press the
✔ The display shows "P.05".
4. Press the
✔ The code for the current setting is displayed.
5. Use the
6. Press the
✔ The set value is saved and is then applied when the system is restarted.
✔ You are then returned to the menu and can select another menu item by
pressing the
EN
or button to select the menu item P.02.
button to change the setting.
or button to select the desired temperature unit.
button to save the setting.
or button.
or button to select the menu item P.05.
button to change the setting.
or button to select "1".
button to save the setting.
or button.
Configuring the system software
symbol flashes.
symbol flashes.
15