Dual XDVD251BT Installation & Owner's Manual page 4

Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it
would be subject to dust, dirt or excessive vibration.
Getting Started
• Connect wiring harness as shown on page 6. Consult a qualified technician if you are unsure.
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
• Reconnect negative battery terminal, and test for correct operation.
• Snap trim ring into place (if required).
TYPICAL FRONT-LOAD MOUNTING METHOD
4
INSTALLATION
Preparation
Decorative Ring
Screw (Taptite
Binding Head) 5x6mm
Head Unit
Screw (Taptite
Truss Head)
5x6mm