Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Dual XD28BT
Summary of Contents for Dual XD28BT
- Page 1 XD28BT INSTALLATION/OWNER'S MANUAL AM/FM Receiver with Bluetooth...
- Page 2 XD28BT INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
-
Page 3: Wiring Diagram
XD28BT INSTALLATION Wiring Diagram FUSE When replacing the Antenna fuse, make sure new Connector fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The unit uses one 10 amp ATC fuse located beside the wiring... -
Page 4: Control Locations
XD28BT OPERATION Control Locations 10 11 Preset 1 / Play/Pause Dimmer Preset 2 / Intro Band Preset 3 / Repeat Reset Voice Assist Auxiliary Input Bluetooth Talk USB Port Tune / Track Down Display Mode Preset 6 / Folder Up... -
Page 5: General Operation
XD28BT OPERATION General Operation Press the button to turn the unit on. Press again to Power On/Off turn the unit off. Changing Modes Press SOURCE to select between Radio, USB, Auxiliary Input and Bluetooth. Sources of operation are shown in the display. - Page 6 DISP to 18 FM stations and 12 AM stations automatically. Preset Scan Stations Touch PS to recall each preset station that has been stored in memory for each band. (Available with the Dual Smart Remote App only.)
-
Page 7: Usb Operation
XD28BT OPERATION USB Operation Playing MP3 Files To play MP3 files, insert a USB device containing MP3 files. Track Select Press TUNE to skip to the beginning of the next track. Press TUNE to skip to the beginning of the previous track. -
Page 8: Bluetooth Operation
Complete the pairing sequence from your Bluetooth device. Refer to the owner’s manual for your device for more details. The device name is “Dual Media Player”. The Bluetooth passcode is "1234”. Note: If passcode "1234" does not pair your device to the receiver, use passcode "0000". -
Page 9: Voice Activation
XD28BT OPERATION Dual iPlug P2 Smart App Remote Control Use the Dual iPlug P2 Smart App Remote Control on an Apple or Android smartphone to control the receiver via Bluetooth. Change the mode, station, song, volume, and settings directly from your smartphone without being in the receiver's line-of-sight. -
Page 10: Limited One Year Warranty
Dual dealer and used in the U.S.A. • Call us toll-free at 1-866-382-5476 • E-mail us at cs@dualav.com... -
Page 11: Troubleshooting
XD28BT OPERATION Troubleshooting Problem Cause Action Yellow wire not connected or incorrect Check connections for proper voltage Red wire not connected or Unit will not turn on voltage (11~16VDC) incorrect voltage (no power) Black wire not connected Check connection to ground... -
Page 12: Specifications
XD28BT OPERATION Specifications Tuning range: 87.5MHz-107.9MHz FM Tuner Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: >30dB Frequency response: 30Hz-13kHz Tuning range: 530kHz-1710kHz AM Tuner Usable sensitivity: <42dBu Frequency response: 30Hz-2.2kHz Speaker output impedance: 4 ohms General Line output voltage: 1.2 Volts RMS... -
Page 13: Fcc Compliance
XD28BT OPERATION FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Page 14 Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2023 Dual Electronics Corp. All rights reserved. Other trademarks and trade names are those of their respective owners. NSA011823-V01...