Morning Protocol For The Application Of Your Prose Device - BostonSight PROSE Use And Care Manual

Morning Protocol for Application of Your PROSE Devices
You will need to have a soft towel to be placed on top of a clean work surface where you
1
will apply your device(s).
You will need the following supplies:
2
• An application plunger
• A removal plunger
• A small mirror
• Preservative-free saline
After thoroughly washing and drying your hands with non-moisturizing soap and water,
3
remove your device from the PROSE case.
4 While holding a cleaned and disinfected device gently by the edges, briefly rinse with
preservative-free saline. Under no circumstances should tap water be used for
rinsing.
Apply device(s) to the eye(s) using your preferred application technique.
5
After each use, empty the PROSE case (being careful not to lose the platinum disc) and leave
6
it open to air dry. NEVER clean the PROSE case with alcohol.
NOTE: If you experience a slight stinging sensation upon application of the device in the
morning, remove your device from your eye immediately and rinse your eye thoroughly
with preservative-free saline. Do this until the stinging sensation dissipates. Rinse your
device(s) thoroughly with preservative-free saline and then soak them in fresh saline
solution for at least 5 minutes before re-applying to your eye. When this occurs, it is likely
an indication that the Clear Care catalyst needs to be replaced.
WARNING
Increased eye redness, pain, discharge, sensitivity to light, and/or significant reduction in
vision may signal infection and requires IMMEDIATE attention. Please contact your primary
eye care provider and ask them to keep your PROSE doctor aware of any findings.
disinfection and care a.m.
19