Nightly Disinfection Protocol For Your Prose Device - BostonSight PROSE Use And Care Manual

Hide thumbs Also See for PROSE:
Table of Contents

Advertisement

Nightly Disinfection Protocol for Your PROSE Devices
Wash your hands thoroughly with non-moisturizing soap and dry completely with a
1
lint-free towel before you begin.
Place your device in the palm of your hand. Place one drop of your daily cleaner on the
2
outside surface of the device and rub for 15 seconds. Place another drop on the inner
surface and then rub again for 15 seconds.
DO NOT rub the device between your fingers to clean it. This can cause the
device to warp.
While handling the PROSE device gently by the edges, rinse the device thoroughly
3
with either preservative-free saline or Bausch + Lomb Sensitive Eyes Plus saline or
Clear Care Rinse & Go. Under no circumstances should tap
water be used for rinsing.
Gently separate the basket from the basket assembly by pulling
4
the tab located near the arbor so that the basket is horizontal.
Place the device, bowl side up, into the basket (see photo at
5
right for correct placement). While keeping the basket horizontal,
bring the basket assembly down onto the basket. To avoid
damaging or losing your PROSE devices, DO NOT
attempt to bring the basket up to the basket assembly.
Repeat for the left device and place into the empty basket.
6
Fill the PROSE case with Clear Care solution or 3% hydrogen
7
(
peroxide
H ² O ² ) to the fill line. It is okay if the platinum disc floats up to
the top – the basket will push it back down.
8
Place the basket assembly in the case and secure the cover. DO NOT
over tighten the cover because the threads may split and break. It is okay
if the platinum disc does not sit flat at the bottom of the case. It will still
work properly even if it is wedged on the side of the case.
To properly allow the Clear Care or 3% hydrogen peroxide solution to
neutralize, devices must remain in the case for AT LEAST 6 hours.
NOTE: If you must remove the devices before the disinfection process has ended, rinse
them thoroughly with the saline. Then soak devices in fresh saline, in a clean contact
lens case, for at least 5 minutes. Repeat with fresh saline solution for an additional
5-minute soak. Rinse again with preservative-free saline before applying to your eye. If
using a screw top contact lens case, clean the case with an alcohol wipe and air dry.
disinfection and care p.m.
17

Advertisement

Table of Contents
loading

Table of Contents