Advertisement
Quick Links
Omega Assembly Instructions:
Step 1:
remove staples from the top of the box to avoid damage to you hands and the bike,
and open the top flap
Step 2:
lay the box on its side and slide out the bike. Lift the bike up and remove the packing
material. There will be several zip ties to remove. These can be cut off with heavy duty scissors
or diagonal cutters.
Tools, the charger and parts box will be included in the included box:
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Evelo Omega
Summary of Contents for Evelo Omega
- Page 1 Omega Assembly Instructions: Step 1: remove staples from the top of the box to avoid damage to you hands and the bike, and open the top flap Step 2: lay the box on its side and slide out the bike. Lift the bike up and remove the packing material.
- Page 2 Step 3: Install the front fender: ● Remove bolt from back of fork ● Install bolt through light and fender, and attach securely. Position the fender as high up as possible and tighten the bolts.
- Page 3 ● Tighten the front bolt securely while holding the the nut in place: ● Secure the lower fender strut bolts on both sides (note: it may be easier to complete this procedure after installing the front wheel). Please note the orientation of the black spacer and washer:...
- Page 4 Step 4: Install the front wheel: ● Remove the spacer from the front brake caliper. This may be black, red or yellow ● Remove the front thru axle with the included hex key. It will unscrew in the counter-clockwise direction and can be slid out once the threads are disengaged: ●...
- Page 5 ● Place the stem onto the newly exposed fork. ● Peel back the rubber cover on the top of the stem, giving you access to the bolt.
- Page 6 ● ● Using The Long end of your 5 mm Allen wrench, tighten the bolt until it feels snug ● With just two fingers attempt to rotate the spacers below the stem. You want the bolt tight enough that you cannot turn the spacers with 2 fingers. This creates the proper pressure on the bearings in the steering column.
- Page 7 movement, loosen the two stem clamp bolts as directed above, tighten the top bolt a bit more, tighten the stem clamp bolts and check again. Repeat until there is no movement. Step 6: Install pedals: ● Note that the pedals have a left and right orientation. This will be designated by an “L” and “R”...
- Page 8 Power up and you’re ready to ride! Hold the power button for approximately 3 seconds to power on the bike. Please consult the Omega Quick Start Guide for more details on how to get going on your Omega. The quickstart guide can be found here: https://evelo.com/omega-quick-start...
Need help?
Do you have a question about the Omega and is the answer not in the manual?
Questions and answers