Maintenance; Cleaning; Display Light Bulb Replacement - Hatco Glo-Ray GRBW-24 Installation & Operating Manual

CLEANING

Hatco Glo-Ray Buffet Warmers are designed for
maximum durability and performance, with
minimum maintenance.
WARNING
To avoid any injury, turn the power switch off at the
fuse disconnect switch/circuit breaker or unplug the
unit from the power source and allow to cool
completely before performing any maintenance
or cleaning.
WARNING
To avoid electric shock or personal injury, do not
steam clean or use excessive water on the unit.
WARNING
To prevent electric shock, always unplug the unit
before performing cleaning or maintenance.
WARNING
Units are not waterproof. DO NOT submerge in
water. Do not operate if unit has been submerged
in water.
To preserve the finish of the Glo-Ray Buffet Warmer, it is
recommended that the surfaces be wiped daily with
a damp cloth. Food pans should be removed and
washed. Stubborn stains may be removed with a good
non-abrasive cleaner. Hard to reach areas should be
cleaned with a small brush and mild soap.
CAUTION
Use only non-abrasive cleaners. Abrasive cleaners
could scratch the finish of your unit marring its
appearance and making it susceptible to
soil accumulation.
Clean acrylic surfaces with a common glass cleaner
and nonabrasive paper toweling or a soft cloth.
CAUTION
Only soft cleaning cloths should be used to clean
breath protector(s). Breath protector(s) are made of
shatterproof polycarbonate and will scratch if proper
care is not taken.

DISPLAY LIGHT BULB REPLACEMENT

The display lights are shatter-resistant, incandescent
light bulbs which illuminate the warming area. These
bulbs have a special coating to guard against injury and
food contamination in the event of breakage.
1. To replace a light bulb, disconnect the power supply
from the unit and wait until the unit has cooled.
2. Light bulbs have a threaded base. Unscrew the light
bulb from the unit and replace it with a new specially
coated incandescent light bulb.
NOTE: Hatco shatter-resistant light bulbs meet N.S.F.
standards for food holding and display areas. For 100
and 120 volt applications, use Hatco part #02.30.043.00.
For 220-240 volt applications, use Hatco part
#02.30.058.00.
Only light bulbs which meet or exceed N.S.F.
standards, specifically designed for food holding
areas, must be used. Breakage of light bulbs not
specially coated could result in personal injury
and/or food contamination.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
This product has no "user" serviceable parts.
To avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Parts when service is required.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them
to operate safely in Hatco equipment. It is essential
to use Hatco Replacement Parts when repairing
Hatco equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in electrical
shock or burn.
7

MAINTENANCE

CAUTION
WARNING
WARNING
WARNING
Form No. GRBWM-0302