Accessories; 4" (10 Cm) Adjustable Legs; Front Acrylic Enclosure; Sign Holder - Hatco Glo-Ray GRBW-24 Installation & Operating Manual

ACCESSORIES

4" (10 cm) ADJUSTABLE LEGS

Carefully lay unit on its side. Install legs to bottom of
unit as shown in Figure 6. Hand tighten legs until snug.
Do not overtighten. Return unit to the upright position.
CAUTION
Do not lay unit on the side with the control panel or
damage to unit could occur.
NOTE: Legs are adjustable for leveling the unit. Use
a 5/8" (16 mm) open-end wrench to make leveling
adjustments once the unit is placed in final position.
FRONT & SIDE ACRYLIC ENCLOSURE
(See Figure 7)
1. Place weld screws into holes on top side of acrylic
enclosure and attach acorn nuts, but do not tighten.
2. Position enclosure making sure weld nuts are
inserted into channel (slide into place).
3. Position slide acrylic panels into upper bracket.
4. Place corner "L" brackets so that the front and side
plexi fit into channels.
5. Secure brackets to base by installing metal foot or
leg through bracket and into each corner hole
on base.
6. Tighten acorn nuts until snug.

SIGN HOLDER

Install sign holder using screws supplied in unit.
See Figure 7.
PANS & TRIVETS
Stainless steel food holding pans are available in either
2-1/2" or 4" (6 or 10 cm) depths. These pans are offered
in full-size, half-size or third-size. Optional wire trivets
prevent foods from touching pan bottom.
Form No. GRBWM-0302
Leg Adjustment
Adjust leg using a 5/8"
(16 mm) open-end
wrench and turning
bottom of leg accordingly.
Figure 6. Adjustable Legs.
Figure 7. Acrylic Enclosure Installation.
8
Leg Installation
Acrylic Enclosure