General Flexcolor Settings - Hasselblad FlexColor V4 Software Reference Manual

The Preferences Window
52

General FlexColor Settings

General FlexColor Settings
The bottom of the Preferences window shows the following general
FlexColor settings:
Opening Saved Images
After saving an image as a TIFF file, FlexColor is able to launch the
application of your choice and open the saved image in that application. If
you would like to use this feature, place a check in the Open in checkbox,
then click the Select button. Use the appearing standard file finder
window to locate and select the application you would like to use for
viewing your saved images.
Auto after New Crop
FlexColor includes an auto tonal range function, which analyzes the
cropped image and sets highlight and shadow values accordingly. You
can use it at any time by clicking on the Auto button in the main
FlexColor window.
The Auto after new crop checkbox provides an optional shortcut for using
the auto function. When this checkbox is marked, each time you make a
new crop, FlexColor will immediately analyze the image contained in the
crop area and set highlight and shadow values, just as if you had clicked
on the Auto button.
You can also control this function by holding down the option key as you
define a new crop:
•
If the Auto after new crop checkbox is enabled, then hold down the
option key to make a new crop without invoking the auto function.
•
If the Auto after new crop checkbox is disabled, then hold down the
option key to apply the auto function to your new crop.
NOTE! This function will not update the highlight and shadow settings
when you move or resize an existing crop area; it only responds when you
create a new crop area. If you would like to use the auto function again
Software Reference - FlexColor 4.0 for Camera Backs