The Light Tubes; General; Replacing The Light Tubes - Hasselblad Flextight 949 User Manual

The Light Tubes

General

The Flextight 949 contains two light tubes: one for illuminating reflective
originals from above, the other for shining light through transparencies
from below.
NOTE! The two lamps are of different types and are not interchangeable.

Replacing the Light Tubes

If your scans are suddenly coming out black (or all white if you are
scanning negatives), then one of your light tubes may be defective.
Make a preview using both types of scans (transparent and reflective) to
find out which tube is affected.
•
If transparencies are not working, then the bottom tube may be
burned out.
•
If reflectives are not working, then the top tube may be burned out.
Follow procedure below to replace a tube:
(See Figure 7 opposite).
1. Get the appropriate replacement lamp (ask your Flextight dealer).
2. Turn off and unplug the scanner from the primary power supply.
3. IMPORTANT: Let the light tubes cool down for app. 10 minutes
before proceeding.
3. Remove the front panel (A) by pulling it outwards at the bottom and
lift it off.
4. Remove the two black allen screws (B) (one in each side) using a 3
mm allen key. Do not remove any other screws.
5. Remove the two side panels (C) and (D) by lifting them slightly
upwards and then outwards.
NOTE! It may require a firm push upwards to release the panels.
6. Turn the feed table (E) to upright position.
7. Locate the tube to be replaced and dismount the plug (F).
User's Guide - Flextight 949
Hardware Reference - Flextight 949
The Light Tubes
25
continues...