Hannlomax HX-200 Quick Start Manual

ALARM CLOCK RADIO WITH USB CHARGING
Model : HX-200
Note: Please read and follow these instructions before using your unit.
WARNING
TO PREVENT ELECTRIC SHOCK; DO NOT USE THIS PLUG WITH AN EXTENSION CORD RECEPTACLE OR
OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADES EXPLOSURE.
TO PREVENT FIRE OR SHOCK HAZARD; DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
RISK OF ELECTRIC SHOCK
The lighting flash with
arrowhead symbol, with an
equilateral triangle is intended to
CAUTION: TO REDUCE THE
alert the user to the presence of
RISK OF ELECTRIC SHOCK, DO
un-insulated dangerous voltage
NOT
within the products enclosure
BACK).
that may be of sufficient
SERVICEABLE PARTS INSIDE
magnitude to constitute a risk of
REFER
electric shock to persons.
QUALIFIED
PERSONNEL.
1. Keep these instructions.
2. Heed all warnings.
3. Follow all instructions.
4. Do not use this apparatus near water.
5. Clean only with dry cloth.
6. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
7. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
8. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
9. Only use attachments/accessories specified by the manufacturer.
10. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
2) Unplug the apparatus during lightning storms or when unused for long periods of time.
3) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged
in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been
dropped.
FCC NOTICE
This device compiles with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION
DO NOT OPEN
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
REMOVE COVER (OR
important operating
NO USER
maintenance
instruction in the
SERVICING TO
accompanying the appliance.
SERVICE
-1-
LOCATION OF CONTROL
1 /SOURCE / AL.OFF Button
2 TIME / MEM / M+ Button
3 AL1 / VOL− Button
and
4 AL2 / VOL+ Button
(servicing)
literature
5 HOUR / SKIP− Button
6 MIN / SKIP+ Button
7 SNOOZE/SLEEP/DIMMER Button
8 PM Indicator
9 ALARM1 BUZZER Indicator
CONNECTING THE UNIT TO POWER
Plug AC power adapter to the AC wall outlet. Before switching on the unit, make
sure that the voltage of your electricity supply is the same as that indicated on the
rating plate.
BATTERY BACKUP
Insert two pieces UM-4 batteries into the battery compartment. Be sure to observe
the proper polarity (the "+" and "-" signs) as indicated inside the battery
compartment.
In case of power failure or interrupted AC power, the current time and alarm time
settings, the stored radio stations are preserved in the memory of the unit by
means of battery back-up function.
10 ALARM1 RADIO Indicator
11 ALARM2 BUZZER Indicator
12 ALARM2 RADIO Indicator
13 LED Display
14 Speaker
15 AC Adapter
16 USB Port for Charging (1A)
17 Battery Compartment
-2-