Download Print this page

Before Using The Appliance - Electrolux ECFG3668AS Use & Care Manual

Advertisement

12

BEFORE USING THE APPLIANCE

First power on
Preliminary setup
When setting the clock or a timer, depending on how
you turn the knob, you can set a different increase /
decrease speed for the settable minutes.
• Turn and release: minutes increase / decrease
one by one.
Example: 00:00 > 00:01 > 00:02 > 00:03 > etc.
• Hold turn: minutes increase / decrease one by
one for the first 3 minutes, then the timer switches
directly to the nearest multiple of 15, increasing or
decreasing in 15 minute steps.
Example: 00:00 > 00:01 > 00:02 > 00:03 > 00:15 > 00:30 >
00:45 > 01:00 > 01:15 > etc.
When setting the minutes you will only see the
icon. Once 60 minutes have been exceeded the icon
will also appear.
Blackout management
After a blackout, there can be two scenarios depend-
ing on how long the appliance has been without
power.
1. A few seconds to a few minutes: the appliance
restores the settings and features set before the
power loss event.
2. A few minutes to hours: The appliance does not
save the previous settings and will have to be
reprogrammed.
First power on
When the range is first plugged in, or when the power
supply has been interrupted "12:00 PM" will flash on
the timer display.
It will stop flashing once the current time is set up as
below.
Setting the display clock
1. Press the oven temperature knob to enable the
time selection.
2. The hours can be set by turning the temperature
knob towards the right or left. Press the knob to
confirm the selection.
3. Repeat the same process for setting the
minutes. Press the knob to confirm the selection.
Once the time has been set, the display switches to
standby mode where only the current time is shown.
To adjust the display clock after the initial set up, in the
stand-by mode, just hold turn the temperature knob
left or right for at least 3 seconds, until you see the
hour digits flashing.
The instructions to adjust the clock in detail are the
same as for setting the clock in the case of the first
power on (see "Setting the display clock") starting
from point no. 2.

Advertisement

loading