Mounting The Attachment - Stihl BF Instruction Manual

English
5.2 Machines without bike handle
or loop-handle
The following machines must be retrofitted with a
loop handle and, if necessary, a carrying ring for
a harness/shoulder strap:
– STIHL HL 75, HL 95, HL 100, all versions with
0° gearbox. The BF attachment is not
approved for use on machines with a short
drive tube.
– STIHL SP 81
Retrofit the loop handle – see "Mounting the
Loop Handle".
Retrofit the carrying ring – see "Fitting the Carry‐
ing Ring".
WARNING
Combinations with basic power tools other than
those listed above are not permitted since they
may result in accidents or serious personal
injury.
6

Mounting the Attachment

6.1 Preparing attachment
WARNING
To reduce the risk of injury, always shut off the
engine before converting the basic power tool.
NOTICE
Make sure the work area is clean before mount‐
ing or removing the attachment.
► Rest the power tool on the machine support.
6.1.1 Removing the Protective Cap
If a cap is fitted on the end of the shaft on the
basic power tool:
► Pull the protective cap off the end of the shaft
and keep it in a safe place.
8
If the plug comes out of the shaft when you pull
off the cap:
► Push the plug into the shaft as far as the limit
stop.
6.1.2 Removing the Gearbox or Attachment
Remove any existing gearbox or interchangeable
attachment from the basic power tool.
6 Mounting the Attachment
FCS
FCS
FH/HL
0458-504-0121-B