Install The Door Handle - Kohler K-702010 Installation Manual

Strike Jamb
Seal
Interior
Handle
Screw
Bushing
Threshold

8. Install the Door Handle

Press the glass bushings into the handle holes in the operating panel.
Identify the interior handle - the handle with holes going all the way through. Insert two flathead
screws through this handle and through the holes in the operating glass panel. Slide the bushings
onto the screws.
Align the exterior handle holes with the screws. Tighten the screws from the inside until snug using
the 5/64" hex wrench provided.
NOTICE: Do not overtighten. Overtightening can cause damage to the operating panel.
9. Install the Strike Jamb Seal and the Threshold Seal
NOTICE: Risk of product damage. Do not install the threshold seal under the hinge or the door will not
operate properly.
Insert the strike jamb seal into the strike jamb channel. Trim the excess seal from the top.
Remove the masking tape from the threshold.
Starting at the strike jamb side, install the threshold seal into the groove on the threshold. The seal
runs from the end to the front of the hinge. Notch the foam portion around the strike jamb. Trim the
excess seal at the hinge.
Kohler Co.
Strike Jamb
Install the strike jamb seal,
and trim the excess.
Exterior Handle
Threshold
Seal
Notch the foam portion of the
seal around the strike jamb.
Install the threshold seal.
11
Trim the excess threshold
seal at the hinge.
1011451-2-H