Advertisement
Note: If an RTM is connected to the front blade, make sure that the
handles of both the RTM and the front blade are closed in order to
power up the blade's payload.
6. Wait until the blue LED is switched off, then tighten the face plate
screws which secure the blade to the shelf.
The switched off blue LED indicates that the blade's payload has
been powered up and that the blade is active.
7. 7. If necessary, connect cables to the face plate.
.
ATCA-7367 Quick Start Guide
Technical Assistance
For technical assistance or to report product damage or shortages,
contact your local SMART Embedded Computing sales
representative or visit
https://www.smartembedded.com/ec/support/
Get More Information
For more information on this product, see the ATCA-7367
Installation and Use
documentation, which can be found by using the
Documentation Search at
https://www.smartembedded.com/ec/support/
SMART Embedded Computing, 2900 S. Diablo Way, Suite 190, Tempe, Arizona 85282
manual and other related technical
.
© 2019 SMART Embedded Computing™, Inc. All rights reserved. The stylized "S" and
"SMART" is a registered trademark of SMART Modular Technologies, Inc. and "SMART
Embedded Computing" and the SMART Embedded Computing logo are trademarks of
SMART Modular Technologies, Inc. All other names and logos referred to are trade names,
trademarks, or registered trademarks of their respective owners. These materials are
provided by SMART Embedded Computing as a service to its customers and may be used
for informational purposes only. For full legal terms and conditions, visit
www.smartembedded.com/ec/legal.
Advertisement
