Hardware Installation - NEC N8105-53 User Manual

E-2

2. Hardware Installation

This chapter has described the procedure of attaching this product to the Server, and the related procedure.
Unplug all power cords
Turn the power off and unplug the power before removing the computer's cover. Failure
to do so could endanger you and may damage the adapter or computer
Avoid installation in extreme temperature conditions.
Immediately after the server is powered off, its internal components such as heat sink
are very hot. Leave the server until its internal components fully cool down before
installing/removing any component.
Ground yourself to dissipate any static charge before handling the
adapter.
To prevent any damage on components due to static electricity, make sure to discharge
static electricity from yourself before you touch N8105-53 adapter.
Don't touch uncoated metal parts on adapter.
Never touch N8105-53 adapter's mDP terminals of components or uncoated metal parts
on adapter. Otherwise, taint, erosion or others may cause loose connection. Do not
touch this product with wet or dirty hands.
Excessive force could break the connector.
On installing this adapter, do not insert it by force. Otherwise, N8105-53 adapter and
the server may be damaged.
Don't touch the tip of bracket to other parts of server
When you insert N8105-53 adapter into expansion slot, be careful not to touch the tip of
bracket to other parts of server (such as other components or board). Otherwise, they
may be damaged.
Stay away from the fan.
Keep your hand or hair away from the cooling fan on the adapter.
Failure to follow this warning may get your hand or hair caught in the fan, resulting in
injury.