How To Use Wireless Remote; Group Programming - Feit Electric SHOP/4/840/MM Use And Care Manual

How to Use Wireless Remote

Turns unit ON & OFF
Increases light level
Lowest light level
Set motion sensor
Group Programing
1
Group Programing
□ Program multiple fixtures at once by pressing down and holding a light setting.
□ While holding the desired light setting, walk closer towards the light until it flashes.
□ Fixtures will verify new setting has been received by flashing.
□ While holding the desired light setting, walk closer towards the light until it flashes.
NOTE: Fixture uses Microwave technology for motion detection
which could interfere with WiFi within 5 ft of the unit.
distance
Decreases light level
Set to highest brightness
Press and hold for three seconds
to reset to default setting
Unit will turn off after
pre-selected time if no
motion is detected