Controls And Indicators; Front Panel - Kenwood CS-3025 Instruction Manual

CONTROLS AND INDICATORS

FRONT PANEL

© POWER
Power s w i t c h for the oscilloscope. Pressing this control once turns the power on and
pressing it again turns the power off.
® Pilot Lamp
Lamp lights w h e n the oscilloscope is on.
(3) C A L Terminal
Voltage terminal for calibration of probes. Provides an approximately 1 kHz square w a v e
at 1 V with positive polarity.
0 $ POSITION/PULL x 5 MAG
Rotation adjusts the vertical position of channel 1 trace on the display. Pulling this knob
increases the vertical axis sensitivity 5 times.
® V O L T S / D I V
S e t s the vertical axis sensitivity using the vertical attenuator for channel 1 . T h i s knob
can be switched in a 1-2-5 sequence. Setting the V A R I A B L E knob (6) to the C A L posi-
tion provides calibrated vertical axis sensitivity.
During X - Y operation, this control serves as the attenuator for the X axis or Y axis.
Fig. 2-1
9