Brackets Front-Mounted-Chassis Protrudes From The Rack; Rack-Mount The Router - Cisco CISCO7206 Quick Start Manual

3

Rack-Mount the Router

Cisco 7200
Series
3 1
Rack-mount bracket
1
2 Cable-management bracket
Brackets Front-Mounted—Chassis Protrudes from the Rack
Locate the rack-mount and cable-management brackets and screws (1, 2, 3 in the illustration above) and a Number 2 Phillips
screwdriver.
1. Align the rack-mount bracket (1)—as shown above—to the side of the router. Insert and tighten the screws (3) if you are
not adding the cable-management brackets. Repeat this step on the other side of the router.
Go to the "Two-Post or Four-Post Rack Installation" section on page 10.
2. If you are using the cable-management brackets, align the rack-mount bracket (1) to the side of the router, align the
cable-management bracket (2) over the rack-mount bracket—as shown above—and insert the screws (3) through both.
Tighten the screws. Repeat this step on the other side of the router.
Go to the "Two-Post or Four-Post Rack Installation" section on page 10.
2
3
ETHERNET-10BFL
FAST ETHERNET INPUT/OUTPUT CONTROLLER
M4 x 8-mm Phillips flathead screws
7