Table of Contents
Advertisement
DIAGRAM OF THE CONSOLE
Speed Control
CAUTION:
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) while operating the treadmill. When
the key is removed from the console, the
walking belt will stop.
• Adjust the speed in small increments.
• The training zones marked above the speed
control are general guidelines only. See
page 14 or more information.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
BATTERY INSTALLATION
The console requires two "AA" batteries (not included).
Alkaline batteries are recommended. To install batter-
ies, open the
Battery Cover
battery cover
as shown at
the right.
Press the bat-
teries into the
battery com-
partment, with
Before operating the
Battery
Cover Tab
Batteries
Monitor Display
Key
the negative (–) ends of the batteries touching the
springs. Close the battery cover, push up on the tab,
and then push the tab forward as shown in the inset
drawing. Be sure that the tab locks into place.
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.) In addition,
make sure that batteries are installed in the console.
If there is a thin sheet of clear plastic on the console,
remove it.
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothing. Test
the clip by carefully taking a few steps backward
until the key is pulled from the console. If the key
is not pulled from the console, adjust the position
of the clip as needed.
Follow the steps below to operate the console.
Insert the key fully into the power switch.
1
Note: Inserting the key
will not turn on the dis-
plays. The displays will
turn on when the
DISPLAY button is
pressed or when the
walking belt is started.
If you just installed bat-
teries, the displays will already be on.
8
Pulse Display
Pulse Sensor
Clip
Advertisement
Table of Contents
