Important Charging Notes - Porter-Cable PCC600 Instruction Manual

battery pack to allow it to function at peak capacity. Battery packs should be tuned up
weekly or whenever the battery no longer delivers the same amount of work. To use
the automatic tune-up mode, place the battery pack in the charger and leave it for at least 8
hours.

Important Charging Notes

1. Longest life and best performance can be obtained if the battery pack is charged
when the air temperature is between 65°F and 75°F (18°- 24°C). DO NOT charge the
battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C).
This is important and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while charging. This
is a normal condition, and does not indicate a problem. To facilitate the cooling
of the battery pack after use, avoid placing the charger or battery pack in a warm
environment such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch which turns power off
when you turn out the lights.
c. Move charger and battery pack to a location where the surrounding air
temperature is approximately 65°F - 75°F (18°- 24°C).
d. If charging problems persist, take the tool, battery pack and charger to your
local service center.
4. The battery pack should be recharged when it fails to produce sufficient power
on jobs which were easily done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
Safety Warnings and Instructions: Drills
WARNING
:
Before using tool, read all instructions and cautionary markings on
tool.
WARNING
:
Drill may stall (if overloaded or improperly used) causing a twist.
Always expect the stall. Grip the drill firmly with two hands to control the twisting action
and prevent loss of control which could cause personal injury. If a stall does occur,
release the trigger immediately and determine the reason for the stall before re-starting.
Operating Instructions
Installing and Removing the Battery
Pack From the Tool
CAUTION
:
Make certain the lock-off button is
engaged to prevent switch actuation before
removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery pack
(7) firmly into tool until an audible click is heard as
shown in Figure B.
TO REMOVE BATTERY PACK: Depress the battery
release button (8) as shown in Figure C and pull
battery pack out of tool.
B
C
8