RIOTEC OM7220L Programming Quick Manual

*
Programming Quick Guide
-OM7220L

Installation

Make sure that the scanner has the correct cable to plug in the PC as
below described:
*Note : Please install PL-2303 driver for USB serial

Reset Configuration to Defaults

If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan from A1 to A3 for USB HID or B1 to B5 for
RS232 or USB Serial. This will reset the scanner to its factory defaults.
A1 B1
0006010
A2 B2
A3 B3
0006000
B4
B5
*
*Note: Please install PL-2303 driver for USB Serial.

Barcode Configuration Method:

(Flow chart for setup procedure :)
Start
Configuration

Keyboard Country (For USB HID only)

Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ' \ < > ~
USA
Denmark
France
0001160
Italy
1100000
Turkey F
Keyboard Country (For USB HID only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United
End
Configuration
Japan
Finland
UK
Norway
Turkey Q
1
States: @ | $ # { } [ ] = / ' \ < > ~
Belgium
Germany
Austria
Sweden
1D Symbologies – 1
EAN-8
ENABLE
EAN-13
ENABLE
ISSN
ENABLE
ENABLE ISBN
Codabar
ENABLE
Spain
Russia
Portugal
DISABLE
DISABLE
DISABLE
DISABLE
DISABLE