Raider RD-GST04 User Manual page 42

www.raider.bg
42
to reach the carburetor. Do not drain carburetor if using fuel stabilizer.
4. Remove the spark plug and pour one ounce of engine oil through the spark hole into the
cylinder. Cover spark plug hole with a rag and crank the engine several times to distribute the oil. Replace
spark plug.
Preparing Snow Thrower
1. When storing the snow thrower in an unventilated or metal storage shed, care should be taken
to rustproof the equipment, using a light oil or silicone,coat the equipment, especially any chains, springs,
bearings and cables.
2. Remove all dirt from exterior of engine and equipment.
3. Follow lubrication recommendations in the Maintenance section of this manual.
4. Store equipment in a clean dry area.
malfunction reason
Can not ignite The fuel shut-off valve (if equipped)
is in the "OFF" position.
The ignition key is not complicated.
The fuel is over.
The butterfly valve is in the "STOP"
position - Stop, or the slack ON /
OFF is in the "OFF" position.
The suction is in the "OFF" position
- off.
The engine is set.
The spark plug cable is cranked.
Bad, damaged spark plug.
Stable fuel.
Water in the fuel.
Loss of power 1. Poor ignition of the spark plug
cable.
2. Eliminate too much snow .
3. The tank cap vent hole is
blocked.
4. Polluted or clogged silencer.
The engine 1. The suction cup is in the "OFF"
fades or runs position.
unevenly 2. Clogged fuel line.
3. Stale fuel.
4. Water in the fuel.
5. The carburettor needs adjustment
or repair.
Excessive 1. Loose elements or damage to the
vibration rotor and auger.
removal
1. Toggle the fuel shut-off valve to OPEN-
OPEN position.
2. Set the ignition key.
3. Fill the tank.
4. Move the butterfly valve to the "FAST"
position - QUICK, or move the throttle to
the "ON" position.
5. Move to "FULL" - completely.
6. Wait for a few minutes before
attempting to restart, DO NOT enclose
the enrichment.
7. Connect the cable to the spark plug.
8. Replace the spark plug.
9. Drain the tank and fill with fresh, clean
fuel.
10. Drain the tank and the carburetor and
fill with fresh gasoline.
1. Connect the spark plug cable.
2. Reduce the speed and width of the
path
3. Remove the snow and ice from the
vent cap of the tank cap.
4. Clean or replace the silencer.
1. Move to "FULL" position completely.
2. Clean the fuel line.
3. Drain the tank and fill it with fresh,
clean fuel.
4.Remove the tank and the carburetor
and fill with fresh gasoline.
5. Contact your service center's experts.
1. Tighten all bolts and assemblies.
Replace damaged parts. If the vibrations
continue, contact the service center's
experts.