Fanimation SHOWROOM SUBTLE FPD6236B Series Manual page 9

How to Assemble Your Ceiling Fan
6. Reinstall the hanger ball on the downrod as
follows. Route the black/white, blue, red, gray and
yellow wires through the hanger ball. Position the pin
through the two holes in the downrod and align the
hanger ball so the pin is captured in the groove in the
top of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could create fan
wobble. (Figure 6)
7. Cut off excess lead wire approximately 6 to 9 inches
above top of the top of the downrod. Strip insulation off
1/2 inch from the end of each lead wire. (Figure 7)
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
(continued)
9
Figure 6
Figure 7