Tilt Support Lever For Power Trim And Tilt Model; Cowling Lock Lever (Pull Up Type) - Yamaha F225C1 Owner's Manual

Components
1. Trim tab
2. Bolt
3. Cap
Bolt tightening torque:
42.0 Nm (4.28 kgf-m, 31.0 ft-lb)
EMU26341
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up po-
sition, lock the tilt support lever to the clamp
bracket.
28
ECM00660
NOTICE
Do not use the tilt support lever or knob
when trailering the boat. The outboard mo-
tor could shake loose from the tilt support
and fall. If the motor cannot be trailered in
the normal running position, use an addi-
tional support device to secure it in the tilt
position.
EMU31421

Cowling lock lever (pull up type)

To remove the top cowling, pull up the cowling
lock lever(s) and lift off the cowling. To install
the top cowling, place it in its original position,
and then move the cowling lock lever(s)
downward to lock it in place.
TIP:
When installing the cowling, check to be
G
sure it fits properly in the rubber seal.