Husqvarna 122C Operator's Manual page 12

2. Set the choke control in the choke position.
3. Hold the body of the product on the ground with your
left hand.
CAUTION:
product.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance. Then pull the starter
rope handle quickly and with force until the engine
starts or tries to start.
WARNING:
rope around your hand.
5. Set the choke control in the operation position.
6. If the engine starts, push the throttle trigger lightly
and let the engine run 60 seconds to become warm.
If the engine does not start, pull the starter rope
handle until the engine starts. Then push the throttle
trigger lightly and let the engine run 60 seconds to
become warm.
CAUTION:
rope to full extension and do not let
go of the starter rope handle. This can
cause damage to the product. Release
the starter rope slowly.
To start a warm engine
1. Push the air purge bulb 10 times.
2. Pull the starter rope until the engine starts.
12
Do not step on the
Do not twist the starter
Do not pull the starter
To stop the product
• Push the stop switch to stop the engine.
Note:
The stop switch automatically goes back to its
initial position.
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line
into the grass.
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
4. Use 80 % throttle when you cut grass near objects.
To clear grass with a grass blade
1. Grass blades and grass cutters must not be used on
woody stems.
2. A grass blade is used for all types of tall or coarse
grass.
3. The grass is cut down with a sideways, swinging
movement, where the movement from right-to-left
is the clearing stoke and the movement from left-to-
right is the return stoke. Let the left-hand side of the
blade (between 8 and 12 o'clock) do the cutting.
941 - 008 - 24.06.2022