MartinLogan MP500 Operating Manual page 3

Do not install this equipment in a confined space such as a
case or similar. Install it away from direct sunlight, heat sources,
vibration, dust, moisture, and/or cold.
Do not cover this unit with a newspaper, tablecloth, curtain,
etc. in order not to obstruct heat radiation. If the temperature
inside this unit rises, it may cause fire, damage to this unit,
and/or personal injury.
Install this unit near the AC outlet and where the AC power
plug can be reached easily.
This unit is not disconnected from the AC power source when it
is turned off. This state is called the standby mode. In this state,
this unit is designed to consume a very small quantity of power.
CAUTION: Top surface can become hot.
CAUTION: These servicing instructions are for use by qualified
service personnel only. To reduce the risk of electric shock,
do not perform any servicing other than that contained in the
operating instructions unless you are qualified to do so.
CAUTION: Changes or modifications to this equipment not
expressly approved by MartinLogan for compliance could void
the user's authority to operate this equipment.
FCC WARNING: Changes or modifications not expressly ap-
proved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
DO NOT LOCATE IN THE FOLLOWING PLACES:
To ensure long-lasting use, do not locate the unit:
• Exposed to direct sunlight.
• Near sources of heat such as heaters.
• Highly humid or poorly ventilated.
• Dusty.
• Subjected to mechanical vibrations.
• On wobbly, inclined, or otherwise unstable surfaces.
• Near windows where there is a chance of exposure to rain,
etc.
• On top of an MP500 or another component which dissi-
pates a great deal of heat.
To ensure proper heat radiation, ensure clearance from walls
and other equipment according to the diagram.
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
MP500.
• Connect the equipment into an outlet on a circuit different
from that to which the MP500 is connected.
• Consult the dealer or an experienced radio / TV technician
for help.
Left: 63mm
(2.5 in) or more
POWER STEREO SUB
MP500
Right: 63mm
Above: 15mm
(2.5 in) or more
(0.6 in) or more
2