Repacking Instruction - McIntosh MA7000 Service Manual

REPACKING INSTRUCTIONS
In the event it is necessary to repack the
equipment for shipment, the equipment must be
packed exactly as shown below.
that the four plastic feet are attached to the bottom of
the equipment. Four 1/4 - 20x2-1/4 inch screws and
washers must be used to fasten the unit securely to the
bottom pad and wood skid. This will ensure the proper
equipment location on the bottom pad. Failure to do this
will result in shipping damage.
Use the original shipping carton and interior
parts only if they are all in good serviceable con-
dition. If a shipping carton or any of the interior
part(s) are needed, please call or write Customer
Service Department of McIntosh Laboratory. Refer
to page 3. Please see the Part List for the correct
part numbers.
Quantity
It is very important
57
Part Number Description
1 034052 Shipping carton top
1 034051 Shipping carton bottom
2 034054 Foam Pad (top and bottom)
2 034186 Foam Pad (front and rear)
2 034187 Foam Pad (sides)
1 034136 Inner carton top
1 034137 Inner carton bottom
1 034188 Foam Pad (inner carton)
1 034479 Shipping skid
4 400411 1/4 - 20x2-1/4 cap screw
4 104058 Flat washer
MA7000