Page 1
Only update this firmware if directed to do so by Bryston support personel. Updating firmware other than when recommended to do so by Bryston may cause other issues and require further support by Bryston.
Page 2
Navigate to upload page From the webUI, click FILE. Then click “Go to choose .bin file and Upload page”...
Page 3
BDA-3.14 firmware and not intended for longterm use. Navigate to my.bryston.com navgate to http://my.bryston.com and click the link that corresponds with your BDA-3. Note that it will show up as BDA314BC this time...
Page 4
Navigate to file upload Click the menu in the top right corner, then Firmware Update Click Update Firmware Navigate to file upload Click Browse or Choose File. Select the file downloaded in step 1 BDA3_2020_06C_OldMB.bin Then click Update Firmware. The front power LED will blink green while uploading, blink yellow while programming, then go solid yellow with all input LEDs green.
Version: u2020.06c Troubleshooting BDA-3 appears to reboot but cannot be found on my.bryston.com or IP address leads to page not found error It is likely that you updated with the wrong file. Locate your IP address. go to http://(your ip address)/upload.