Set-Up - MK Diamond Products MK-2013HE GX390 Owner's Manual

MK-20 SERIES
FRONT POINTER ALIGNMENT
The Front Pointer is set in line at the factory. However, the pointer should be checked for proper
alignment with the blade after every use.
(A)
Using a straight edge, care-
fully mark a line 12 feet long on
a smooth level concrete surface.
Place Saw parallel to line; lower
Blade and center it over the line.
PRE-START INSPECTION
The pre-start inspection should be performed before beginning any job.
(A)
Inspect Blade for damage for
cracks and wear, replace if nec-
essary. Verify the Blade is cor-
rect for the material being cut.
(B)
With the Blade centered over the
line and the Saw Frame parallel
to the line, lower the front Pointer
assembly and position the pointer
over the line.
(B)
Inspect Engine for leaks.
Make sure surfaces are clean
and unobstructed.
19
(C)
Adjust the Pointer in or out if the
orange wheel is off the line by loos-
ening the thumbscrew on the end of
pointer. Align orange wheel with line
and tighten thumbscrew. Roll saw
along the entire length of the line to
ensure proper alignment.
(C)
Inspect the saw for general dam-
age and/or loose hardware. Check
that the equipment covers and
guards are in place and securely
fastened.

SET-UP