Table of Contents
Advertisement
MK-20 SERIES
(G)
Tighten Blade Shaft Nut holding
the Blade Shaft steady. Lower and
close Blade Guard.
FILLING FUEL TANK
Refer to Engine Manual for detailed instructions.
WARNING 1. Gasoline is highly flammable and explosive. You can be burned or seriously
2. To fuel, stop engine if running, and allow it to cool.
3. Fuel in a well-ventilated area.
4. Keep gasoline away from appliance pilot lights, barbecues, electric appliances,
5. Wipe up spills immediately. Do not start engine until spill is dry.
6. When filling the fuel tank do not overfill. Always leave enough area for
NOTE:
1. Fuel can damage paint and plastic. Be careful not to spill fuel when filling the
fuel tank. Damage caused by spilled fuel IS NOT covered under the warranty.
2. DO NOT use stale or contaminated gasoline, or an oil/gasoline mixture.
(A)
Remove the Fuel Cap.
NOTE:
injured when handling fuel.
power tools, etc.
expansion due to environmental heating.
Ensure fuel level is 1" below the
Raise the blade as high as possible when
maneuvering so that the blade will not strike
the pavement. The blade is spinning when-
ever the saw is running.
1 inch (25mm)
from throat
Maximum Fuel
Level
(B)
throat of the Fuel Tank.
18
ASSEMBLY
Advertisement
Table of Contents
