Basic Programming - ADJ STAGE SETTER 8 User Manual

B A S I C P R O G R A M M I N G
PROGRAMMING CHASE PATTERNS:
You may create up to 8 Chase Patterns consisting of up to 32 steps (scenes) each. These chases are
stored to the Chase Buttons (17).
To initiate programming, follow the steps below:
1. Tap the Record Button (14) to activate record mode. The record LED will illuminate to indicate that
record mode has been activated.
2. Tap the Chase Button (17) you wish to record to. Once you selected a chase bank to store your
chase, the corresponding chase LED will begin to flash, indicating which Chase Button (17) was
selected. You may now begin the programming process.
PROGRAMMING CHASE PATTERNS (2X8 AND 8X8 MODES):
When in 2x8 or 8x8 mode, each chase can only be programmed using Scene X Sliders (2), and each
step will only include Channels 1-8.
Example:
1. Programming a 32 step chase into the Chase 5 Bank Button using the Scene X Sliders (2).
2. Tap the Record Button (4), and the record LED will illuminate.
3. Tap the Chase 5 Button (17), and the Chase 5 LED will begin flashing.
4. Move the desired Scene X Sliders (17) to the levels desired as the first step of this chase.
5. Tap the Record Button (4) to record this step into memory. All channel LEDs should flash once
and the LCD (7) will read "01".
6. Repeat steps 3 and 4 until the LCD (7) reads "end." This indicates that the maximum of 32 steps
has been reached.
7. After the maximum of 32 steps has been programmed, the device will automatically exit record
mode.
8. If you wish to record fewer steps in to your program, you can exit the record mode manually by
tapping on the Blackout Button (15) once. This will cause the device to exit record mode, and the
program will consist of only the steps entered before the Blackout Button was tapped.
NOTE: While in record mode, all other functions will be locked.
15