Table of Contents
Advertisement
1-4
MERCHANDISERS SHIPPED
WITH END INSTALLED
If the merchandiser was shipped with the end
installed, two long bolts were used to hold the
shipping brace to the end. If the shipping bolts
are reinserted after removing the brace, they
will extend into the product area. T
sure To replace These bolTs wiTh The shorTer
. NSF requires any bolt or screw
bolTs provided
in the product area be capped or cut off if it
has more than three exposed threads.
Be careful not to damage the factory
installed end while moving the
merchandiser.
Do not remove shipping braces
until the merchandisers are
positioned for installation.
P/N 3074287_H
K
END SHIPPING BRACES
Move the merchandiser as close as possible to
its permanent location, then remove all packaging.
Check for damage before discarding packaging.
Remove all separately packed accessories such
as kits and shelves.
,
herefore
be
Do not remove end braces until joining begins.
Recycle wooden braces and hardware.
SHIPPING RIDER
Some merchandisers are shipped on a rider to
protect the factory installed front legs, and to
make positioning the merchandiser easier. To
remove the rider, remove bolts attaching rider to
each leg.
Shipping Rider
Ultra Low
Front Cases
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
Remove 6 Screws and
Wooden Supports Prior to
Moving Case into Position
(rear rail will remain
attached to merchandiser)
Shipping Braces
Advertisement
Table of Contents
