Personalisations; Setting The Temperature; Functions - Indesit WITL 90 Instructions For Use Manual

Hide thumbs Also See for WITL 90:
Table of Contents

Advertisement

Available languages

Available languages

Personalisations

C

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table).
The temperature can be lowered, or even set to a cold wash ( ).
Setting the spin speed
Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes
Maximum spin speed
Cottone
900 rpm
Synthetics
800 rpm
Wool
800 rpm
Silk
no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed for each
programme.
Note. To avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by conti-
nuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set
frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.

Functions

To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.
Option
Effect
Delays the start of the
wash by up to 9 hours.
Delay Timer
Bleaching cycle de-
signed to remove the
toughest stains.
Bleaching
This option reduces
the amount of creasing
on fabrics, making
Easy iron
them easier to iron.
Increases the efficiency
of the rinse.
Extra Rinse
Comments
Pess the button repeatedly until the LED corresponding to the
desired delay is turned on. The fifth time the button is pressed, the
function will be disabled.
N.B.: Once you have pressed the Start/Reset button, the delay
can only be decreased if you wish to modify it.
Please remember to pour the bleach into extra compartment 4
(see page 10).
This option is incompatible with the EASY IRON option.
Recommended when the appliance has a full load or with large
quantities of detergent.
GB
.
Enabled with
programmes:
All
2, 3, 4,
,
,
8 and
Rinse cycle.
1, 2, 3, 4,
,
, 8, 9, 10, 11.
1, 2, 3, 4,
,
, 7, 8, 9, 10,
11, 13, 14, and
Rinse cycle.
9

Advertisement

Table of Contents
loading

Table of Contents