Personalisations; Setting The Spin Cycle; Setting The Delay Timer; Setting The Temperature - Indesit WIXE 127 Instructions For Use Manual

Personalisations

FUNCTION buttons
appears; this decreases every hour until the start of the cycle. In this phase, the "delay" can only be modified by
decreasing it.
The Delay Timer regulation is enabled with all programmes.

Setting the temperature

If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature needs
to be regulated, a fixed
set will be displayed and the
indicates a cold wash cycle (press it again to go back to the maximum value); stop on the desired value, after
approximately 2 seconds the setting is accepted: the symbol
The temperature adjustment is enabled with all wash programmes.

Functions

To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
If you set a function that is incompatible with another function you selected previously, only the last one selected
will be enabled.
Function Effect
Bleaching cycle
designed to
Stain remove the
removal toughest stains.
Increases the
efficiency of the
rinse.
Extra Rinse
This option
reduces the
amount of
creasing on
fabrics, making
them easier to
Easy iron iron.

Setting the spin cycle

If, when the appliance is switched on, the KNOB is positioned on
a programme with a spin cycle,
and the maximum spin speed allowed for the programme set
will be displayed, and the
values lower until they reach OFF, which indicates that the spin
cycle has been excluded (press it again to go back to the
maximum value); stop on the desired speed, after approximately
2 seconds the setting is accepted: the symbol
The spin cycle setting is enabled with all the programmes except
for 6 and the Draining cycle.

Setting the Delay Timer

Press the button
display, while the relative symbol flashes.
Press the button again and "1h" appears, that is, a delay of one
hour (this can reach up to 24h); stop on the "desired" delay; after
approximately 2 seconds the setting is accepted, following which,
the time for the set programme appears on the display and the
symbol
If you now press the START/RESET button, the set "delay"
appears. Press button and the maximum temperature allowed for the programme
icon flashes. Press it again and the temperature lowers until it reaches OFF, which
Comments
Please remember to pour the bleach into extra compartment 4
(see page 8).
This function is incompatible with the EASY IRON function.
Recommended when the appliance has a full load or with large
quantities of detergent.
When this function is set, programmes 4, 5, 6 will end, with the
laundry left to soak (Anti-crease), and the relative button flashes:
- to conclude the cycle, press the START/RESET button or the
EASY IRON button;
- to run the draining cycle alone, set the knob to the relative
symbol and press the START/RESET button.
This function is incompatible with the STAIN REMOVAL function.
a fixed appears. Press button
icon flashes. Press it again and the
and you will see the word OFF on the
remains on.
remains fixed.
GB
remains fixed.
Enabled with
programmes:
2, 3, 4,
Rinse cycle.
1, 2, 3, 4, 7,
8, 9, 11, 12,
Rinse cycle.
3, 4, 5, 6, 7, 8,
9, Rinse
cycle.
7