Bowflex TC1000 Assembly Manual page 5

I N S T A L L I N G S T E P S
Step 9: SECURING THE CONSOLE/ HANDLEBAR ASSEMBLY
Locate the following for this step: Figure 9-1
PARTS:
TreadClimber® Base & Treadle Assembly from
Step 8.
HARDWARE:
Six (6) 5/16" x 1" Button Head Screws NOTE:
Two (2) of the 5/16" x 1" Button Head
screws are already inserted into the bottom of
the right and left upright supports.
Six (6) 5/16" flat washer SAE
TOOLS:
3/16" Hex Key (included)
With the help of another person, carefully lift
the upright and remove the 5/16" x 1" button
head screw at the base of the support on the
right side. Carefully lower the upright on to the
upright bracket base, without damaging the
electrical cable. Repeat on the left side.
Attach the upright using (6) 5/16" x 1" button
head screws and (6) 5/16" flat washers SAE (3
per upright). Tighten with the provided 3/16"
hex key (see Figure 9-1). Repeat this process
on the remaining bracket.
NOTE: Tighten the front (2) screws first (1 per
upright) and then the (4) side screws (two per
outward side of upright). Tightening in this
order will result in a tighter fit.
5