Police Force PFCL2F54 Instructions

Advertisement

CHARGING BATTERY

WARNING: Never attempt to charge standard (non-rechargeable) batteries. Doing so could result in injury and
will void the warranty.
This unit operates on one rechargeable 18650 Li-Ion battery (included) and we recommend fully charging it first. To do
so, insert the battery into the charger following the polarity diagram shown on the charger. Flip out the charging plug on
the back of the charger and plug it into a standard wall outlet. IMPORTANT: Do not charge for longer than 5 hours
or continue to charge once the light on the charger turns green. Once the light on the charger changes from red to
green, the battery is fully charged and should be removed from the charger.

INSTALLING THE BATTERY

1. To access the battery compartment, unscrew the end cap (at the opposite end of the light) by turning it
counterclockwise.
2. Insert the fully charged battery into the flashlight. The positive (+) end of the battery should be inserted first
(toward the head of the light). Screw the end cap back on by turning it clockwise.

USING THE FLASHLIGHT

1. To turn on the light, press the rubber Push Button Tail Switch (located at the opposite end of the light) until it
clicks and the light turns on. This unit features five light modes: High, Medium, Low, Strobe and SOS.
2. To change the light mode, "soft press" the rubber Push Button Tail Switch by applying light pressure (if you press
too hard it will click and turn off).
3. To turn the flashlight off, "hard press" the rubber Push Button Tail Switch until it clicks.
4. Recharge the battery when you notice the light becoming weaker.
PFCL2F54 Instructions
Push button tail switch
18650 Li-Ion Battery
Unscrew end cap
to insert battery
Heavy duty ballistic clip
Battery Charger
with flip out plug
Revised 8/2/2019

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PFCL2F54 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Police Force PFCL2F54

  • Page 1 PFCL2F54 Instructions Unscrew end cap to insert battery Heavy duty ballistic clip Push button tail switch Battery Charger with flip out plug 18650 Li-Ion Battery CHARGING BATTERY WARNING: Never attempt to charge standard (non-rechargeable) batteries. Doing so could result in injury and will void the warranty.
  • Page 2 WARRANTY Cutting Edge Products, Inc. extends a Lifetime warranty to the PFCL2F54 for the product against defects in materials or workmanship, with the following exceptions: 1. The warranty does not cover damage resulting from exposure to water in excess of the IP65 rating, accident, misuse or abuse, lack of reasonable care, the affixing of any attachment not provided with the product, loss of parts, or recharging the unit in any manner not in accordance with the instructions above.

Table of Contents