Steps For Installation - Haier HLT364XXQ User Manual

Steps for Installation

Select a away suitable location for the washer on a hard even surface
from direct sunlight or heat source e.g. radiators, base board heaters,
cooking appliances etc.Any floor unevenness should be corrected with
the leveling legs located on the bottom corners of the washer.The
washer must be placed at room temperature.You must not place washer
where the temperature is at below freezing.
Installing Your Washer:
Read through these instructions carefully before installation.
1. Connect the hot and cold water inlet hoses to the hot and cold water
faucet.
Cold water inlet hose
Hot water inlet hose
2. Connect the other end to the corresponding washer inlet located at the
back of machine.
Note: You may have to use pliers to tighten the coupling. Do not over tighten
because you may cause damage to the valve.
You should use the new hose-sets supplied with the washer. Old
hose-sets should not be reused.
C
H
16