Table of Contents
Advertisement
To work properly, the plunger rod of the tool must remain
clean and free of all caulk and adhesive material. If
material does get on the plunger rod mechanism, clean
the material off according to the directions of the caulk or
adhesive manufacturer.
When the tool is shut off by the electronic overload
protection system, always wait for 3 to 5 seconds before
depressing the trigger to restart. Frequently depressing
and releasing the trigger under these circumstances may
cause interior damage to the caulk gun.
Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an Authorized Service Center.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
a s w a s t e . T h e m a c h i n e , a c c e s s o r i e s
a n d p a c k a g i n g s h o u l d b e s o r t e d f o r
environmental-friendly recycling.
SYMBOL
Safety Alert
V
Volts
min
Revolutions or reciprocations per minute
-1
Direct current
Please read the instructions carefully before
starting the machine.
Recycle
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
English
5
Advertisement
Table of Contents
