Cisco 1701 Start Manual page 6

Use SDM to Configure the Router
Assign a new IP address to the PC's Ethernet interface; place it on the same subnet as the router's
Step 1
Ethernet port, which you assigned in
configured a DHCP server on the router, configure the PC to obtain an IP address automatically.
Figure 4
Figure 4
to a switch using a straight through cable.
Step 2 Open a web browser on the PC, and enter the SDM URL, using the new IP address that you gave the
LAN interface (https://new-IP-address). In the example shown in
following:
https://172.16.30.1
The https://... specifies that the Secure Socket Layer (SSL) protocol be used for a secure connection.
You can use http://... if SSL is not available.
Step 3 Enter the username and password that you specified in
the Startup Wizard" section on page
The SDM Overview window appears, as shown in
To continue configuring your router, see the
Cisco Security Device Manager (SDM) Quick Start Guide
6
Configure the PC with an IP Address on the New Subnet
Crossover cable
Example static
or dynamic IP address:
172.16.30.2/255.255.255.248
shows that you can connect the PC directly to the router using a crossover cable, or connect it
Step 7 of Task 3. See Figure 4
172.16.30.0 subnet
Example configured IP address:
172.16.30.1/255.255.255.248
Or
Straight through cables
Step 7
3.
Figure 5.
"Using SDM" section on page
for an example configuration. If you
Figure 4, you would enter the
in the "Task 3: Start SDM, and Complete
7.
78-16254-01