Ryobi RY903622 Operator's Manual page 11

3,600 watt generator
Table of Contents

Advertisement

Available languages

Available languages

SYMBOLS
the area thoroughly before occupying
again. Ensure the generator is located
in an open, outdoor area. Always point
exhaust away from occupied structures.
Never run the generator in enclosed areas
(e.g. not in a house or garage).
DO NOT tamper with, adjust, or modify the carbon monoxide (CO) sensor module
on your generator.
FUEL WARNING
No smoking when filling with gasoline. Do not
overfill. Full level is 1 in. below the top of the fuel
neck. Stop the engine for five minutes before
refueling to avoid the heat from the muffler ignit-
ing fuel vapors.
ENGINE LUBRICANT WARNING
You must add lubricant before first operating
the generator. Always check the lubricant level
before each operation. The lubricant level should
always register between the hatched areas on
the dipstick. The unit is equipped with a sensor
which will automatically shut off the engine if the
lubricant level falls below a safe limit.
GROUNDING WARNING
This generator does not include a ground rod or
copper wire. Call a qualified electrician for local
grounding requirements.
HOT SURFACE WARNING
Do not touch the muffler or aluminum cylinder of the engine. They are very
HOT and will cause severe burns. Don't put any flammable or combustible
materials in the direct path of the exhaust.
CLEARANCE WARNING
While operating and storing, keep at least 3 feet of clearance on all sides
of this product, including overhead. Allow a minimum
of 30 minutes of "cool down" time before storage.
Heat created by muffler and exhaust gases could
be hot enough to cause serious burns and/or ignite
combustible objects.
SPARK ARRESTOR
Operation of this equipment may create sparks that
can start fires around dry vegetation. A spark arrestor may be
required. The operator should contact local fire agencies for laws
or regulations relating to fire prevention requirements.
FUEL CAP WARNING
Never remove fuel cap when unit is running. Shut off engine and
allow the unit to cool at least five minutes. Remove cap slowly
to release any pressure built up in the fuel system and to avoid
the heat from the muffler igniting fuel vapors.
Page 7 — English

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ry903622vnm

Table of Contents