Table of Contents
Advertisement
Cleaning and maintenance
en
Drainage hose on the siphon
blocked
Turn the programme selector to Off.
1.
Pull out the mains plug.
Loosen hose clip, carefully remove
2.
drainage hose. Residual water may
run out.
Clean drainage hose and siphon
3.
spigot.
Re-attach the drainage hose and
4.
secure the connection point with the
hose clip.
30
Filter in the water inlet hose
blocked
:
Warning
Danger of death!
Do not immerse the Aqua-Stop safety
device in water (it contains an electric
valve).
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any programme (except Spin
2.
/Drain 0/[).
Select A Start/Reload. Allow the
3.
programme to run for approx. 40 s.
Turn the programme selector to Off.
4.
Pull out the mains plug.
Clean the filter on the tap:
5.
Disconnect the hose from the water
tap.
Clean the filter with a small brush.
Clean the filter on the back of the
6.
appliance:
Remove the hose from the rear of
the appliance.
Take out the filter with pliers and
clean it.
Connect the hose and check for
7.
leaks.
Advertisement
Table of Contents
