Figure 3.14 Wireless - 2.4Ghz > Basic > Bridged Repeater - Advantech EKI-6333AC-2GD Series User Manual

Item
Channel bandwidth
Submit
Bridged Repeater Mode
To access this page, click Wireless - 2.4GHz > Basic and select Bridged Repeater
in Operation Mode.
Figure 3.14 Wireless - 2.4GHz > Basic > Bridged Repeater
The following table describes the items in the previous figure.
Item
Wireless Network
Operation Mode
WDS
Main SSID
BSSID
Scan AP
Extender SSID
Management Frame
Protection
Tx/Rx
Operation frequency
Country Code
Description
Click the drop-down menu to select the band and channel
bandwidth: 11b/g - Non-HT (Legacy), 11n - HT20, 11n - HT40, or
11ac - VHT 80 (5GHz only).
Click Submit to save the values and update the list.
Description
Click the drop-down menu to select an operation mode: Access
Point, Client, Bridged Repeater.
Click the radio button to enable or disable the Wireless Distribution
System (WDS) to allow your device to create WDS link with peer
devices.
Enter the source SSID network to be repeated.
Displays the basic service set identifiers (BSSID) for the device.
Click to rescan and detect nearby Access Points.
Enter the SSID name to use for transmitting the Main SSID signal.
The extender SSID boosts the signal obtained from the Main SSID
and allows clients to connect efficiently.
Click the radio button to enable, disable, or set the function to
optional. The wireless feature increases the security of the
management frames, standard: IEEE 802.11W-2009.
Click to select the transmission signal stream, single or dual
stream.
Click the drop-down menu to select the country code to specify
different selectable channels. Some specific channels and/or
operational frequency bands are country dependent.
30 EKI-6333AC-2GD Series User Manual