Operation - HAMPTON BAY HB-4133-OR Use And Care Manual

Wiring Options (continued)
4
Wiring motion sensing lights to
control each other
IMPORTANT: Total fixture ratings must not exceed 500 Watts (4.2 A).
When wiring so either motion sensor turns on both
motion lights (Master / Master):
□
Strip the red wire in both light fixtures.
Connect the red wire of one fixture to the red
wire of the second fixture.
□
Connect all white wires together.
□
Connect all black wires together.
□
Connect all ground wires together.

Operation

1
Setting the sensor for testing
NOTE: When the "ON-TIME" switch is set to the "TEST"
position, the light fixture will operate during the day or
night. The light will stay on for 5 seconds after all motion
is stopped.
□
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
□
Set the "ON-TIME" switch to the "TEST"
position.
□
Slide the "SENSITIVITY" switch to the "M"
position.
NOTE: The motion sensor will need to completely warm
up (90 seconds) before beginning the setup process.
A
TEST 1 5 10 MIN
ON-TIME
2
LO - M - HI
SENSITIVITY
8
NOTE: In most installations, an additional wire (same
gauge as existing house wire) will have to be installed in
the house to connect the two fixtures as master / master.
White to white
Master
Light
Ground to ground
Wiring multiple motion sensing lights
to control each other
Determining the motion sensor
coverage area
□
Perform a "walk test": walk in an arc in front
of the motion sensor (B).
□
Watch the light (A). The light (A) will come on
when motion has been detected.
□
Stop, wait for the light (A) to turn off, and then
begin walking again.
□
Continue this process until the detection zone
has been established.
B
Red
Master
to red
Light
Black to black