Setup & Suggestions; Basic Use; Setting Time - Geo Knight Digital DK20 16x20 Manual

Setup & Suggestions
• Locate the press on a firm, sturdy work surface. It is recommended
that the front two holes on the feet of the machine be bolted down for
best ease-of-use.
• The height of the bench/work space the press is located on would be
ideally 27" to 32" high.
• Attach the power cord from the rear to the backside of the controler.
There is a power inlet on the back panel of the control box for the
power cord.
• The press should remain in the unclamped/open position when not in
use. Do not leave the heater block closed on the table surface when
hot for long periods of time if not using. The top platen may either be
open, or fully retracted backwards when not in use.

Basic Use

Setting Time

The time setting is always editable in the default operating mode
of the controller. The left two digits of the time display are minutes.
The right two digits are seconds. This can be changed to Hours/
Minutes in the User Options Menu.
• Use the Up & Down arrow keys to change the time.
• Hold the Up or Down arrow key down to increment the values quickly.
After a brief pause, the values will accelerate.
• Press the Up & Down arrow keys together to clear the setting to 00:00
• When the press is closed, the timing cycle starts. The "TIMING"
indicator will appear.
• When the timing cycle is finished, the "DONE" indicator will appear.
• Depending on the timer alarm chosen, the alarm may continue to sound
at the end of the timing cycle until the press is opened.
• When the press is opened up, the "OPEN" indicator will appear.
4