Advertisement
Quick Links
KD-G734
Installation/Connection Manual
GET0429-002A
[UI]
This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.
WARNINGS
To prevent short circuits, we recommend that you disconnect the battery's negative terminal and make all electrical connections before installing the unit.
• Be sure to ground this unit to the car's chassis again after installation.
Notes:
• Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio dealer.
• It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than 50 W, change
"AMP GAIN" setting to prevent the speakers from being damaged (see page 24 of the INSTRUCTIONS).
• To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.
• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.
PRECAUTIONS on power supply and speaker connections:
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.
Parts list for installation and connection
The following parts are provided for this unit. If any item is missing, consult your JVC car audio dealer immediately.
A / B
Hard case/Control panel
E
Power cord
I
Rubber cushion
Heat sink
C
Sleeve
F
Washer (ø5)
J
Handles
1
© 2007 Victor Company of Japan, Limited
D
Trim plate
G
Lock nut (M5)
K
Remote controller
0107DTSMDTJEIN
EN
H
Mounting bolt (M5 × 20 mm)
L
Battery
Advertisement
Related Manuals for JVC KD-G734
Summary of Contents for JVC KD-G734
- Page 1 © 2007 Victor Company of Japan, Limited This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.
- Page 2 INSTALLATION (IN-DASH MOUNTING) The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits. • If you are not sure how to install this unit correctly, have it installed by a qualified technician.
- Page 3 ELECTRICAL CONNECTIONS Typical connections Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit. The leads of the power cord and those of the connector from the car body may be different in color. Connect the colored leads of the power cord in the order specified in the illustration below.
- Page 4 Before connecting the external components, make sure that the unit is turned off. • To use JVC CD changer, Apple iPod or JVC D. player, set the external input setting to “CHANGER” (see page 24 of the INSTRUCTIONS). • To use other external components via KS-U57 or KS-U58, set the external input setting to “EXT IN” (see page 24 of the INSTRUCTIONS).