Page 1
CD RECEIVER KD-G735 KD-G735 For canceling the display demonstration, see page 4. For installation and connections, refer to the separate manual. INSTRUCTIONS GET0428-005A [UT]...
Page 2
CAUTION: CAUTION: Warning: • Be careful not to drop the disc when it ejects. • If this does not work, reset your unit. 5 ∞ • Your preset adjustments will also be erased (except the registered Bluetooth device, see page 12).
Page 3
CONTENTS INTRODUCTIONS OPERATIONS EXTERNAL DEVICES ® Lever CAUTION: The lever comes out if you pressed the button SETTINGS while the panel is detached. If this happens, push the lever back into lock position before attaching the panel. • Do not raise the volume level too much, as this will REFERENCES block outside sounds, making driving dangerous.
Preparation Cancel the display demonstration and set the clock • See also page 23. When the power is turned off: Check the current clock time When the power is turned on: Change the display information Turn on the power. Ÿ Enter the PSM settings.
Basic operations Using the control panel CD * USB * CD-CH */IPOD */ FM/AM D.PLAYER * EXT IN BT-PHONE BT-AUDIO * You cannot select these sources if they are not ready or not connected. 5 ∞ FM/AM CD/USB BT-PHONE FM/AM CD/USB IPOD/D.PLAYER BT-PHONE/BT-AUDIO...
Page 7
Warning: To prevent accidents and damage ∞ ∞ 2 ∞ Returns to the previous menu. ∞ Confirms the selection. ∞ OPERATIONS...
Disc operations Open the control panel and insert the disc. Playback starts automatically. To stop play and eject the disc Change the display information • Press SRC to listen to another playback source. Prohibiting disc ejection To cancel the prohibition, repeat the same procedure.
Disc type TRK RPT FLDR RND FLDR RPT DISC RND TRK RPT DISC RND RPT OFF RND OFF Listening to the USB device * You can connect both MTP (Media Transfer Protocol) devices and USB mass storage class devices. Attaching a USB memory * See page 29.
Page 11
To stop play and detach the USB device Cautions: Press: Hold: TRK RPT FLDR RPT FLDR RND DISC RND RPT OFF RND OFF Change the display information * If the file does not have Tag information or “TAG DISP” is set to “TAG OFF”...
Using the Bluetooth ® devices Bluetooth Adapter Registering a Bluetooth device Registration (Pairing) methods Select “NEW.” Select “OPEN.” OPEN Enter a PIN (Personal Identification Number) code to the unit. SEARCH * Some devices have their own PIN code. Enter the specified PIN code to the unit.
Page 13
Connecting/disconnecting a registered device Searching for available devices Deleting a registered device Connecting a special device EXTERNAL DEVICES...
Using the Bluetooth cellular phone Change the display information Select “BT-PHONE.” Ÿ Enter Bluetooth menu. Make a call or setting using the Bluetooth setting menu. (See pages 15 and 25.) When a call comes in..When a text message comes in..When “AUTO ANS”...
Page 15
Making a call Call history Phone book Direct dialing Voice command Speak the name you want to call. Preset phone number EXTERNAL DEVICES...
Presetting the phone number You can preset up to six phone numbers. [Hold] Using the Bluetooth audio player If playback did not start automatically, operate the Bluetooth audio player to start playback. • Refer also to page 13 for connecting/disconnecting/deleting a registered device.
Listening to the CD changer Change the display information Preparation Select “CD-CH.” Ÿ Select a disc to start playing. Press Hold Disc type Press: Hold: Press: Hold: Continued on the next page EXTERNAL DEVICES...
Listening to the iPod / D. player Change the display information Interface adapter for iPod D. player interface adapter Preparation Select “IPOD” or “D. PLAYER.” Ÿ Select a song to start playing. Selecting a track from the menu Enter the main menu. Confirm the selection.
General settings — PSM You can change PSM (Preferred Setting Mode) items listed in the table that follows. : Initial) • : Display demonstration will be activated automatically if no operation Display is done for about 20 seconds, [4]. demonstration •...
Page 24
Indication Item Setting, [reference page] MUTING 1/ MUTING 2 SCROLL * ONCE AUTO WOOFER HIGH EXT IN * CHANGER EXT IN TAG DISP TAG ON TAG OFF AMP GAIN LOW PWR HIGH PWR IF BAND AUTO WIDE Some characters or symbols will not be shown correctly (or will be blanked) on the display. Displayed only when one of the following sources is selected—FM, AM, CD, USB, or Bluetooth.
Bluetooth settings Setting menu AUTO CNT (connect) Select “BT-PHONE” or “BT-AUDIO.” LAST ORDER AUTO ANS (answer) Enter the Bluetooth menu. Select “SETTING.” REJECT MSG-INFO (message info) Select a setting item. AUTO MANUAL MIC SET (microphone setting) Change the setting accordingly. VERSION SETTINGS...
More about this unit Ejecting a disc General Turning on the power Turning off the power Playing a CD-R or CD-RW FM/AM Storing stations in memory Disc Caution for DualDisc playback General...
Page 29
Playing an MP3/WMA disc Playing MP3/WMA/WAV tracks from a USB device * The parenthetic figure is the maximum number of characters for file/folder names in case the total number of files and folders is 271 or more. Continued on the next page REFERENCES...
Page 30
Changing the source Detaching a USB device Bluetooth operations General...
Page 31
Warning messages for Bluetooth operations Title assignment ERR CNCT General settings—PSM ERROR UNFOUND LOADING WAIT RESET 8 iPod or D. player Notice: For iPod users: For D. player users: REFERENCES...
Page 33
Symptom Remedy/Cause * Folder that is physically empty or folder that contains data but does not contain valid MP3/WMA/WAV track. Continued on the next page REFERENCES...
Page 34
Symptom Remedy/Cause * For Bluetooth operations, refer also to the instructions supplied with the Bluetooth Adapter.
ENGLISH ELECTRICAL CONNECTIONS Typical connections / Before connecting:...
Page 42
Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker • leads of this unit unused. JVC Amplifier JVC Amplifier JVC Amplifier Connecting the external components / CAUTION: JVC CD changer JVC CD Apple iPod Apple iPod JVC D. player JVC D. External component External component...