Table of Contents
Advertisement
Display
E:35
alternating with
-10 (Suitable for spe-
cial models)
H:95
alternating with
"Ÿš
when programme is
finished
H:32
alternating with
"Ÿš
when programme is
finished
Other displays
Faults and what to do about them
Faults
Water is leaking from the
appliance.
The door cannot be
opened.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
Cause/Remedy
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
No water detected in drying phase, may get bad drying result.
~ "Filter in the water supply is blocked" on page 42
The unbalanced load detection system has interrupted the spin cycle because the
laundry is unevenly distributed. Distribute small and large items of laundry evenly in
the drum.
Turn the programme selector to Û (Off), wait for five seconds and then switch it on
again. If the display appears again, call customer services.
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
■
~~~ (Rinse hold = no final drain) is activated (depending on the
■
model). Continue the programme by selecting 0/p (Spin/Drain) and
pressing inicio/pausa+carga (Start/Reload) .
The temperature in drum is too high to open the door.
■
The safety function is activated. Stop the programme?
■
The water level in drum is too high.
■
Can the door only be opened by the emergency release?
■
~ "Emergency release" on page 43
Programme does not start?
■
Is the tap turned on?
■
Could the filter in the water supply be blocked?
■
~ "Filter in the water supply is blocked" on page 42
Note:
If an additional water filter has been installed (depending on the
model), check for contaminants and clean if required ~ separate installa-
tion and cleaning instruction for water filter.
Is the supply hose kinked or trapped?
■
Faults and what to do about them
en
45
Advertisement
Table of Contents
