Electrical Connection; Before Washing For The First Time; Transportation - Siemens WN44G200ES Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Electrical connection

:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Never touch or hold the mains plug
with wet hands.
Only pull out the mains cable by the
plug and never by the cable, as this
could damage it.
Observe the following information and
ensure that:
Notes
The mains voltage and voltage
indicated on the appliance (rating
plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
The appliance is only connected to
an alternating current via a properly
installed earthed socket.
The mains plug fits the socket.
The earthing system is properly
installed.
The mains cable is only replaced by
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
extension cables are used.
If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
all times.
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Positioning and connecting
Before washing for the first
time
The appliance was inspected thoroughly
before leaving the factory. To remove
any residual test water, run the algodón/
algodão 90°C (Cottons 90°C)
programme the first time without
laundry.
Note:
The appliance must have been
installed and connected properly.
~ "Positioning and connecting"
on page 12
Never switch on a damaged
appliance.
Insert mains plug.
1.
Turn the water tap on.
2.
Close the door. Do not load any
3.
laundry.
Select the algodón/algodão 90°C
4.
(Cottons 90°C) programme.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
6.
Dispenser II.
Add standard detergent to Dispenser
7.
II according to manufacturer's
instructions for light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
8.
Select inicio/pausa+carga (Start/
9.
Reload) .
When the programme ends, turn the
10.
programme selector to Û (Off).
Your appliance is now ready for use.

Transportation

e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose. ~ Page 42
Drain any residual water.
3.
~ Page 41
Disconnect the appliance from the
4.
mains.
en
19

Advertisement

Table of Contents
loading

Table of Contents