After-Sales Service; Environmental Concerns - IKEA UDDARP Manual

ENGLISH

After-Sales Service

Before contacting the After-Sales Service:
1. See if you can solve the problem yourself with the help of
the suggestions given in the "What to do if ..." table.
2. Switch the appliance off and back on again it to see if the
fault persists.
If after the above checks the fault still occurs, contact IKEA
Authorized Service Centre.
Always specify:
• a brief description of the fault;
• the type and exact model of the appliance;
• the service number (number after the word Service on the
rating plate);
• your full address;
• your telephone number.
If any repairs are required, please contact IKEA Authorized
Service Centre (to guarantee that original spare parts will be
used and repairs carried out correctly).

Environmental concerns

Disposal of packaging materials
The packaging material is 100% recyclable and is marked with
the recycle symbol .
The various parts of the packaging must therefore be disposed
of responsibly and in full compliance with local authority
regulations governing waste disposal.
Disposal of household appliances
This appliance is manufactured with recyclable or reusable
materials.
Dispose of it in accordance with local waste disposal regulations.
For further information on the treatment, recovery and recycling
of household electrical appliances, contact your local authority,
the collection service for household waste or the store where
you purchased the appliance. This appliance is marked in
compliance with European Directive 2012/19/EU, Waste Electrical
and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help
prevent negative consequences for the environment and human
health.
The symbol on the product or on the accompanying
documentation indicates that it should not be treated as domestic
waste but must be taken to an appropriate collection center for the
recycling of electrical and electronic equipment.
TRANSPORT AND HANDLING
Never lift the dryer by holding it at the worktop.
1. Unplug the dryer.
2. Make sure that door and water tank are properly closed.
3. If the drain hose is connected to your sewage system, fix the
drain hose on the rear of the dryer again (see Installation
Guide).
Power consumption
off-mode (Po) - Watts
left-on mode (Pl) - Watts
Programs
Eco Cotton *
Eco Cotton
Synthetics
*This is the reference programme for the energy label
and suitable to dry normal wet cotton laundry. This is the
most efficient programme in terms of energy consumption
for drying wet cotton laundry. (Standard/Default starting
configuration)
Heat Pump System
The heat pump contains fluorinated greenhouse gases,
contained in a hermetically sealed unit. This sealed unit contains
0,18 kg of the F gas R134a. GWP = 1430 (1 t CO2).
xxxx xxxx
xxxxxxxxxxxx xxxxxxxxxxxx
0.50
1.00
Kg kWh Minutes
8 1.78 194
4 1.15 135
4 0.73 95
16